Replacing the main accumulator sphere

1. Put the car in lowest position.
2. Loosen the bleed screw.
3. Unscrew the sphere on the main accumulator (on models with manual gearbox you must under the car).
4. Put a little LHM on the new gasket and fasten it on the accumulator, not the sphere.
5. Put a little mineral grease on the contact surfaces, and screw on the new sphere. Tighten only with your hands.
6. Start and let the car idle for 5 to 10 min. to remove air bubbles.
7. Tighten the bleed screw and lift the car up and down a few times.
8. Check the LHM level.