Remove the finisher. Unclip two clips up and one under and remove the lamp. Disconnect the connector.

The finisher removed.

Water in the daytime-running lamps/direction indicators

If the lamp is fogged, or there may even stand several centimeters of water inside, it is likely that one of the mounts is broken.

Remove the lamp and open it. Get it dry; maybe use a hair dryer. Do not touch the reflectors. If these have become dull: Fill them half full with warm water and dishwasher detergent and shake for a long time. Rinse with clean water and air dry.

Put silicone on the gasket and mount the lamp. Then tighten hard with thin plastic covered wire where the mount is broken.

Here we can see one of the broken mounts.

Wire applied.


Visitors who use this website and rely on any information do so at their own risk
leirdal.info is in no way affiliated with Automobiles Citroën

 © www.leirdal.info 

Valid XHTML 1.0 Transitional